How to Regrip

Using the hook blade tool, make a slice all the way down the old grip. Then, peel off the grip fully from the club shaft.

Place the tape on the shaft of the club. Be sure to leave an inch of tape off the end of the shaft. Once applied, smooth out any bumps and twist the excess tape and push it into the end of the shaft.

Pour solvent on the tape. Make sure the tape is covered fully with solvent.

Place your finger over the hole of the cap end and pour solvent into it. You want a good coating of solvent inside the grip, so it can slide onto the shaft easier.

Using one fluid motion, slide the grip onto the shaft. If you prefer the logo facing down, rotate the grip 180 degrees before sliding it onto the shaft. 

To ensure your grip is straight, you can look at the logo or the tick marks on the end cap and mouth of the grip. 

Tip: Use a towel to cover the cap end when you’re sliding the grip on, because solvent can spray out of it.